tag:blogger.com,1999:blog-8603841722282537425.post1841233800336738253..comments2008-09-07T15:53:19.526-04:00~petehttp://www.blogger.com/profile/10509320262926555033noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-8603841722282537425.post-55348561955809260052008-09-07T15:53:00.000-04:002008-09-07T15:53:00.000-04:00Not sure about Hardy, you can run the iwprv without any params and if it shows the ioctls then you should be able to set it.~petehttp://www.blogger.com/profile/10509320262926555033noreply@blogger.comtag:blogger.com,1999:blog-8603841722282537425.post-84899786066729328952008-09-07T14:07:00.000-04:002008-09-07T14:07:00.000-04:00Thanks a bunch! I have a Broadcom BCM4328 chip in my laptop and a few kernel updates ago the wl driver was added, although ssh didn't work. I'll try the manual way, I guess it should work in Hardy too?Tero Keinänenhttp://www.blogger.com/profile/06802873812704083574noreply@blogger.comtag:blogger.com,1999:blog-8603841722282537425.post-38363474511623149252008-09-07T14:06:00.000-04:002008-09-07T14:06:00.000-04:00Thanks a bunch! I have a Broadcom BCM4328 chip in my laptop and a few kernel updates ago the wl driver was added, although ssh didn't work. I'll try the manual way, I guess it should work in Hardy too?Tero Keinänenhttp://www.blogger.com/profile/06802873812704083574noreply@blogger.comtag:blogger.com,1999:blog-8603841722282537425.post-18400233791829540852008-09-07T13:22:00.000-04:002008-09-07T13:22:00.000-04:00Thank you! I've been looking for a solution to that problem.jbrhttp://www.blogger.com/profile/12444720604540522971noreply@blogger.com